Range Rover Evoque: Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
- Copper Hammer
- Hydraulic press
- Punch
- Vise
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel Knuckle (204-01 Front Suspension, Removal and Installation).
3.
- Special Tool(s): JLR-204-806
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
4.
- General Equipment: Vise
- General Equipment: Copper Hammer
- General Equipment: Punch
5.
- Special Tool(s): 204-305
- General Equipment: Hydraulic press
6. Clean all the mating faces and reusable parts thoroughly and check for damage.
7.
8. NOTE: Note the orientation of the component prior to removal.
- Special Tool(s): 204-727A
- General Equipment: Hydraulic press
Installation
1. CAUTION: Make sure that the area around the component is clean and free of foreign material.
NOTE: Make sure that the component is installed to the noted removal position.
Special Tool(s): JLR-204-808
2.
- Special Tool(s): JLR-204-807
- General Equipment: Hydraulic press
3.
4.
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
5. Refer to: Wheel Knuckle (204-01 Front Suspension, Removal and Installation).
READ NEXT:
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installat
Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this pro
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
SEE MORE:
Front Airbag Deployment - Driver and Passenger
CAUTION: If
the front airbags are deployed, the following components must be replaced:
Driver airbag module
Steering wheel
Passenger airbag module
Instrument panel
Fly leads (where applicable) connecting front airbag modules to SRS
harness
All seat belt buckle pre-tensioner
All occupied
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
