Range Rover Evoque: Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these components.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure that all openings are sealed. Use new blanking caps.
1. Remove the rear wheel.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
2.
3.
4.
5.
6.
7. CAUTION: Make sure to protect the paintwork.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1.
2. To install, reverse the removal procedure.
READ NEXT:
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door
A-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
B-Pillar Upper Trim Pane
SEE MORE:
Fuel System - General Information
Capacities
Fuel System Pressure Release GTDi
2.0L Petrol
Draining
1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety
Precautions (100-00 General Information, Description and
Operation).
2. Remove the fuel pump fuse.
3. Remove the fuel filler cap.
4. Start the engine and allow it
Anti-trap protection
Closing a window or roof
blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a position
where it could be trapped. Even with
an anti-trap system death or serious
injury could occur
