Range Rover Evoque: Blower Motor LHD AWD/LHD FWD

Special Tool(s)

412-140
Remover/Installer, Blower Motor

Removal

NOTES: Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

7.

Range Rover Evoque. Climate Control

8. Torque: 10 Nm

Range Rover Evoque. Climate Control

9.

Range Rover Evoque. Climate Control

10.

Range Rover Evoque. Climate Control

11.

Range Rover Evoque. Climate Control

12.

Range Rover Evoque. Climate Control

13. Special Tool(s): 412-140

Range Rover Evoque. Climate Control

14.

Range Rover Evoque. Climate Control

15. CAUTION: Make sure that the special tool is correctly located.

NOTE: With assistance remove the component.

Range Rover Evoque. Climate Control

Installation

1.

Range Rover Evoque. Climate Control

2.

Range Rover Evoque. Climate Control

3. To install, reverse the removal procedure.

READ NEXT:

 Blower Motor RHD AWD/RHD FWD, RHD

Special Tool(s) 412-140 Remover/Installer, Blower Motor Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essenti

 Climate Control Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: LH illustration shown, RH is similar. NOTE: The procedure must be carried out on both sides.

 Evaporator LHD

Removal NOTES: The removal of this component involves cutting an aperture in the evaporator housing wall and cutting through the high and low pressure A/C lines. A service repair kit is supplied to c

SEE MORE:

 Engine - Diagnosis and Testing

Principles of Operation For a detailed description of the engine system, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol) Inspection and Verification CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptabl

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only active when the ambient light drops below a predetermined level. Note: It is not recommended that high

© 2011-2025 Copyright www.rrevoque.org