Range Rover Evoque: Airbag system
The components that make up
the
airbag system are sensitive to
electrical or physical interference,
either of which could easily damage
the system and cause inadvertent
operation or a malfunction of the
airbag module.
To prevent malfunction of the airbag system always consult your Dealer/Authorised Repairer before fitting any of the following: - Electronic equipment such as a mobile phone, two-way radio or in-car entertainment system.
- Accessories attached to the front of the vehicle.
- Any modification to the front of the vehicle.
- Any modification involving the removal or repair of any wiring or component in the vicinity of any of the airbag system components, including the steering wheel, steering column, instrument or fascia panels.
- Any modification to the fascia panels or steering wheel.
READ NEXT:
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
Parts and accessories
The fitting of non-approved
parts and
accessories, or the carrying out of
non-approved alterations or
conversions, may be dangerous and
could affect the safety of the vehicle
and occupants and
Road testing dynamometers (rolling roads)
It is essential that any dynamometer testing is
carried out only by a qualified person, familiar
with the dynamometer testing and safety
procedures practised by Dealers/
Authorised Repairers.
SEE MORE:
Rear seat head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
event of a collision.
Do not drive or carry passengers with
the head restraint removed from an
Front Halfshaft RH LHD AWD/RHD AWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant velocity (CV) joints do not over art
