Range Rover Evoque: Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions.

2. Pass the tether strap over the seat back and beneath the head restraint.

3. Attach the tether strap hook to the tether anchor point on the back of the seat.

Ensure that the tether strap hook is facing the correct way.

4. Tighten the tether strap according to the manufacturer's instructions.

READ NEXT:

 Airbag supplementary restraint system (SRS)

Airbag supplementary restraint system (SRS) 1. Front passenger’s airbag 2. Curtain airbags 3. Side airbags 4. Knee-bolster airbag 5. Driver’s airbag Note: The general location of airbags f

 Airbag operation

For the airbags to operate correctly the roof lining and door post trims must be in good condition, correctly fitted, and free from obstruction. Any damage, wear, or incorrect fitment should b

 Disabling the passenger airbag (not Australia)

Crash test data and statistics show that the safest place for a child to be restrained is in a child seat correctly fitted to the vehicle's rear seat. Do not use a child restraint on a seat pr

SEE MORE:

 Suspension Top Mount

Removal NOTES: The suspension top mount is manufactured from mild steel and RP220. The service panel is serviced not fully spot welded. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2.

 Rear Seat Entertainment Module (REM)

 CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle.  NOTES: If the control module or a component

© 2011-2025 Copyright www.rrevoque.org