Range Rover Evoque: Automatic systems
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control / Automatic systems
Gradient Acceleration Control (GAC) and Hill Start Assist are not active while HDC is operating.
GAC will limit vehicle acceleration on steep descents, allowing the driver to feel more in control of the vehicle.
Hill Start Assist activates when starting a hill ascent from a stationary position. When the foot brake is released Hill Start Assist smoothly releases the brake pressure, allowing the vehicle to move away without rolling backwards.
Any fault with GAC or Hill Start Assist will be indicated by the DSC warning lamp being illuminated and a message in the message centre.
READ NEXT:
Parking aids
Parking aids
1. Parking aid on/off switch. The switch
indicator will illuminate.
When reverse gear is selected, the front
and rear parking sensors are activated
automatically.
To turn off, pre
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors.
SEE MORE:
Seats - System Operation and Component Description
Control Diagram
NOTE: A = Hardwired; N = Medium speed CAN (controller area network) bus; O
= LIN (local interconnect network)
bus
CONTROL DIAGRAM - FRONT POWER OPERATED NON-MEMORY SEATS
Driver seat forward-rearward motor
Driver seat recline motor
Driver seat height motor
Driver lumbar pump
D
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
© 2011-2025 Copyright www.rrevoque.org
