Range Rover Evoque: Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
4. NOTE: Measure and mark a 70mm section of the pipe using the clamp as a guide.
5. NOTE: Discard the bolt and clamp.
Installation
1. Torque: 20 Nm
2. Torque: 6 Nm
3. NOTE: Using a suitable tool, cut a 70mm gap from the coolant pipe.
4. Torque: 3 Nm
5. CAUTION: Protect the surrounding paintwork and body from the movement of the cutting blades.
NOTE: Following the indent on the bumper and using a suitable tool, cut a 26mm hole in the front bumper cover.
6.
7. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
8. CAUTION: Make sure the retaining clip is secured correctly.
9.
10. NOTE: Make sure all ground connections are correctly installed. Torque: 10 Nm
11. Fill the engine coolant and test the block heater for correct operation.
Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
12. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
READ NEXT:
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure f
Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle sta
SEE MORE:
Introduction to rear seat entertainment (RSE)
The RSE system consists of two screens.
Separate programmes can be viewed or heard
by rear seat occupants. Supervisory control is
made from the front seats. Audio and video
programmes for each or both sides of the RSE,
can be selected from the Supervisor screen.
The remote control can be locke
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose or pipe end which is to be
disconnected.
Obtain appropriate blanking plugs or caps before disconn
