Range Rover Evoque: Electric parking brake (EPD)

the rear The parking brake operates on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface.
Do not rely on the parking brake to operate effectively, if the rear wheels have been immersed in mud or water.

Note: If the vehicle is used in severe off-road conditions (e.g. wading, deep mud, etc.), additional maintenance and adjustment of the parking brake will be required. Consult your Land Rover Dealer/Authorised Repairer.

READ NEXT:

 Epb manual use

Epb manual use 1. To apply the parking brake, with the vehicle stationary, pull up the lever and release it. The parking brake warning lamp will illuminate. It is important to confirm that th

 Epb automatic use

EPB will be applied automatically if the ignition is switched off and the vehicle speed is below 3km/h (2mph). To prevent automatic operation, when the vehicle is stationary, press and hold the EP

 Epb warning indicators

If the system detects a fault with the EPB, the amber brake warning indicator will illuminate accompanied by a message on the message centre. If the system detects a fault while EPB is operating,

SEE MORE:

 Leather

Use only cleaning products specifically designed for use on leather. Do not use solvents. Do not use chemical, alcohol, or abrasive materials, as they will cause rapid deterioration of the leather. The use of products which are not approved will invalidate your warranty. If you are in any

 Differential Case Vehicles With: M66 6-Speed Manual Transmission AWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the LH rear wheel and tire. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). 3. Refer

© 2011-2026 Copyright www.rrevoque.org