Range Rover Evoque: Front Seat
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors.
Failure to follow these instructions may result in personal injury.
Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. CAUTION: Make sure that new bolts are installed.
Torque: 40 Nm
4. CAUTION: Make sure that new bolts are installed.
Torque: 40 Nm
5.
6. CAUTIONS:
Protect the surrounding paintwork to avoid damage.
Care must be taken to avoid damaging the surrounding components.
Remove the seat through the door aperture.
7. NOTE: Do not disassemble further if the component is removed for access only.
Torque: 4.5 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Backrest Cover
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
Rear Seat Backrest Cover 5-Door
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions
Front Seat Track Motor
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. Raise the front se
SEE MORE:
Wiper blade replacement
Fit only replacement wiper blades that are
identical to the original specification.
Before changing a wiper blade, the wiper arms
must be set in the ‘service’ position as follows;
Note: The Smart Key must remain in the
vehicle while wiper blades are replaced.
1. Ensure that the ignition is
Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the butt
