Range Rover Evoque: Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW
Windscreen VIN - China only
VIN label - UK, Europe and ROW
- Type/Approval Number - If shown
- VIN Number
- Gross Vehicle Weight
- Gross Trailer Weight
- Front Axle Weight
- Rear Axle Weight
- Colour Code Group
VIN label - China
- Vehicle VIN Number
- Engine Type/Capacity/Power
- Occupancy
- Build Date
- Gross Vehicle Weight
- Gross Trailer Weight
VIN label - Gulf markets
- Build Date
- Model year
- Vehicle VIN Number
Tire Data Label - UK, Europe and ROW
- Tire Size
- Tire Pressures
Certification/Tire data label - NAS only
- Vehicle VIN Number
- Bar Code Identification
- Tire Pressures
Tire pressure label - Canada only
- Tire Pressures
- Vehicle VIN Number
- Vehicle Type
VIN number identification
VIN number - UK, EU and ROW
VIN number - NAS and Canada
2.2 Liter Diesel Engine Serial Number
The 2.2 Liter Diesel Engine Serial Number is stamped on the RH side of the cylinder block.
2.0 Liter Petrol Engine Serial Number
The 2.0 Liter Petrol Engine Serial Number is etched into the RH side of the engine block.
Automatic Transmission Serial Number
The Automatic Transmission Serial Number is stamped on the LH side of the transmission casing.
Manual Transmission Serial Number
The Manual Transmission Serial Number is stamped on the transmission casing.
Rear Differential Serial Number
The Rear Differential Serial Number is stamped on the side of the differential casing.
Power transfer unit
The number is stamped on the underside of the casing.
READ NEXT:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Lifting
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
SEE MORE:
Restraints
Control Module (RCM)
WARNINGS:
TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP
POWER SUPPLY MUST BE
DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM
(SRS) COMPONENTS. TO
DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND
WAIT ONE MI
Rear Side Member Upper Side Extension
Removal
NOTES:
The rear side member upper side extension is manufactured from mild steel.
If a new Rear side member upper side extension is being replaced in combination
with a rear side member closing
panel some MIG plug welds can be substituted for spot welds on installation
within this procedu
