Range Rover Evoque: Rear Quarter Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3.
4.
5.
6. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
7.
8. NOTE: Do not disassemble further if the component is removed for access only.
9.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
B-Pillar Upper Trim Panel 3-Door
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
4.
5. Torque: 6 Nm
6.
7. NOTE: 5-door illustration shown, 3-door is similar.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
Interior Trim and Ornamentation
Torque Specifications
READ NEXT:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
panel is replaced
2. For additional information relating to this repair procedure please see
the foll
Front End Body Panels
Torque Specifications
Fender
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installation).
2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3.
4.
5.
6. Torqu
