Range Rover Evoque: Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

 Automatic systems

Gradient Acceleration Control (GAC) and Hill Start Assist are not active while HDC is operating. GAC will limit vehicle acceleration on steep descents, allowing the driver to feel more in control of the vehicle. Hill Start Assist activates when starting a hill ascent from a stationary positio

 Programmed position loss

The powered tailgate may lose its position memory if there are multiple object detections or if battery voltage is low. Powered operation may be inhibited. To reset the tailgate; 1. Manually close the tailgate. 2. Press a release switch. 3. Allow the tailgate to power fully open or to the pre

© 2011-2025 Copyright www.rrevoque.org