Range Rover Evoque: Rear Side Member Lower Side Extension
Removal
NOTE: The rear side member lower side extension is manufactured from mild steel.
1. The rear side member lower side extension is replaced in conjunction with:
- Rear bumper cover
- Rear bumper
- Rear lamp mounting panel
2. For additional information relating to this repair procedure please see the following: For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) / Body Repairs (501-25A Body Repairs - General Information, Description and Operation) / Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) / Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation) / Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Remove the rear lamp mounting panel.
For additional information, refer to: Rear Lamp Mounting Panel (501-30A Rear End Sheet Metal Repairs - 3-Door, Removal and Installation).
4. Release and lay aside the wiring harness.
5.
6. Separate the joints and remove the old panel.
Installation
1. Prepare the old and new panel joint surfaces.
2. NOTE: With panel in position check for access to spot weld the joints. Offer up the new panel and clamp into position. Check alignment, if correct, proceed to next step, if not, rectify and recheck before proceeding.
3. Remove the new panel.
4. NOTE: If access is available you can spot weld these joints. Drill holes in new panel ready for MIG plug welding if required.
5. Offer up the new panel and clamp into position. Check alignment, if correct, proceed to next step, if not, rectify and recheck before proceeding.
6. Spot weld if access is available.
7. MIG plug weld.
8. Dress all welded joints.
9. Apply a zinc rich primer to any bare metal surfaces at this stage.
10. NOTE: Make sure all underbody joints are sealed following this repair procedure
The installation of associated panels and mechanical components is the reverse of removal.
READ NEXT:
Rear Lamp Mounting Panel
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inn
Water Drain Panel Section
Removal
NOTE: The water drain panel section is manufactured from mild steel.
1. The water drain panel section is replaced in conjunction with:
Rear bumper cover
Tailgate
Quarter panel
Rear lamp m
Rear Wheelhouse Front Extension
Removal
NOTE: The rear wheelhouse front extension is taken from the rear
wheelhouse outer and is manufactured from mild steel.
1. The rear wheelhouse outer is replaced in conjunction with:
Rear bum
SEE MORE:
Portable media connections
Portable media devices can be connected to
the media hub located in the cubby box. The
portable devices that you can connect to the
system include:
- USB mass storage devices (e.g. a memory
stick). Devices must use FAT or FAT32 file
format.
- iPod (iPod Classic, iTouch, iPhone and
Nano are s
Air Conditioning
Component Location
COMPONENT LOCATION
High pressure line
Low pressure servicing connection
High pressure servicing connection
Thermostatic expansion valve
Evaporator
Refrigerant pressure sensor
Receiver/Drier
Condenser
A/C (air conditioning) compressor
Low pressure line
COMPONENT LOCATI
