Range Rover Evoque: Trailer electrical connection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Towing / Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer.
When a trailer electrical connection is made and the vehicle’s direction indicators are used, the trailer warning indicator will flash in time with the direction indicators.
READ NEXT:
Powered tailgate
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
Parking aids
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
Trailer stability assist (TSA)
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Powered tailgate opening height
The maximum opening height can be set as
required. This is useful in parking areas with
low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you
want to set as the maximum height. Press
any tailgate control to stop movement at
the required position. Final pos
Transmission Vehicles With: M66 6-Speed
Manual Transmission AWD - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery
© 2011-2025 Copyright www.rrevoque.org
