Range Rover Evoque: Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to trigger, or render the
system inoperative.
Do not use any electrical test
equipment or devices in the vicinity of
SRS components or wiring. Doing so
may cause the system to trigger, or
render the system inoperative.
All of the following operations should be
carried out only by a Dealer/Authorised
Repairer, or suitably qualified person:
- Removal or repair of any wiring or
component in the vicinity of any SRS
components.
- Installation of electrical, or electronic, equipment and accessories.
- Modification to the front or sides of the vehicle exterior.
- Attachment of accessories to the front or sides of the vehicle.
READ NEXT:
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
Lighting control
Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where
SEE MORE:
Suspension System - General Information
Coil Spring Suspension
Wheel Alignment Specification (All Markets) - Front
NOTE: All figures are with vehicle at 'Showroom' ride height - full
fluids, full tank of fuel, no occupants/luggage, tires
inflated to normal pressures
Wheel Alignment Specification (All Markets) - Rear
NOTE: All figures a
Active On-Demand Coupling Module
Removal
NOTE: If a new Active on-demand coupling module is installed, the throttle
valve must also be installed.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign m
