Range Rover Evoque: Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety.

Follow the manufacturer's instructions for fitting and use, then adjust the seat belt to suit.

READ NEXT:

 Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to t

 Tether anchorage points (Australia only)

WARNING: Child restraint anchorages are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, ha

 Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions. 2. Pass the tether strap over the seat back and beneath the head restraint. 3. Attach the tether strap hook to the tet

SEE MORE:

 Continuously Variable Damping Module (CVD)

Adaptive Damping Control Module (SUMB)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES

 Glass Roof Panel Blind

Removal CAUTION: When removing and installing the glass roof panel blind, extreme cleanliness must be observed at all times. NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. NOTE: The procedure must be carried out on both sides. Refer to: A-Pillar Trim Panel

© 2011-2026 Copyright www.rrevoque.org