Range Rover Evoque: Brake temperature
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control / Brake temperature
In extreme circumstances, the HDC system may cause brake temperatures to exceed their pre-set limits. An HDC warning will be displayed in the message centre. HDC will then fade out and become temporarily inactive.
Once the brakes have reached an acceptable temperature, the message will disappear (or the warning indicator will extinguish) and HDC will, if required, resume operation.
READ NEXT:
System fault
If a fault is detected in the HDC system, an HDC
warning will be displayed in the message
centre.
If the fault is detected while the system is
operating, HDC will then fade out.
If a fault is det
Automatic systems
Gradient Acceleration Control (GAC) and Hill
Start Assist are not active while HDC is
operating.
GAC will limit vehicle acceleration on steep
descents, allowing the driver to feel more in
control
SEE MORE:
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
Rear Wheelhouse Outer
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
© 2011-2025 Copyright www.rrevoque.org
