Range Rover Evoque: Conditions causing automatic engine restart
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Conditions causing automatic engine restart
The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program are selected
- battery charge becomes low
- brake vacuum has been reduced (eg using the brake pedal repeatedly with the
engine off)
READ NEXT:
Disabling stop/start
Disabling stop/start
To switch the system off (preventing automatic
stop/start) press the ECO switch. The LED
indicator will extinguish to confirm that the
system is off.
Note: The engine will
Eco stall recovery
In the event that the engine stalls, it can be
restarted by fully depressing the clutch pedal.
Note: Automatic stall restart will only operate
once. If the engine is stalled a second time the
engi
Emission control system
Land Rover vehicles are fitted with emission
and evaporative control systems. In many
countries it is unlawful to tamper, modify or
replace such equipment and legal penalties
apply if the laws are
SEE MORE:
Touch
Screen (TS)
Touch Screen Display (FCDIM)
The table below lists all Diagnostic Trouble Codes (DTCs) that could be
logged in the Multifunction Display Module, for
additional Diagnosis and Testing information refer to the relevant Diagnosis and
Testing Section.
For additional information, refer to: Information
Component Description
DESCRIPTION
Engine Control Module (ECM)
The ECM is located at the rear of the engine compartment, between the
bulkhead and the engine sound insulation. The ECM is located in a plastic molded
carrier which in turn is located in a bracket attached to the vehicle structure.
The ECM is connected to t
© 2011-2025 Copyright www.rrevoque.org
