Range Rover Evoque: Decreasing cruise speed

To reduce cruising speed, press and hold control (4). Release the switch when the desired speed is reached, the new speed will be set and maintained.

The set speed can be decreased in steps of 2km/h (1mph), by briefly pressing control (4).

READ NEXT:

 Suspending and resuming cruise control

Suspend cruise control with a single press of control (3). To resume cruise control at the previous set speed, press control (2). RES (2) should be used only if the driver is aware of the set

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

SEE MORE:

 Block Heater

Removal 1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures). 2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation). 3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installat

 Lifting

Two-Post Lift WARNING: Make sure that the vehicle is stable before commencing work. CAUTION: If the drive shaft(s) are to be removed, release the parking brake and select NEUTRAL 'N' in the transmission in order that the shaft(s) can be rotated when the vehicle is raised to the desired height.

© 2011-2026 Copyright www.rrevoque.org