Range Rover Evoque: Front/Rear Door Latch
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1 2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Rear Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Exterior Rear Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1.2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Liftgate Latch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 25 Nm
3. Torque: 25 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always co
Wipers and Washers - Component Location, System Operation and Component
Description
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Le
SEE MORE:
Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. Th
Engine oil check
Check the engine oil weekly.
If any
significant or sudden drop in oil level is
noted, seek qualified assistance.
Never allow the oil level to fall below the
lower mark or notch on the dipstick.
If the message ENGINE OIL PRESSURE
LOW is displayed, stop the engine as
soon as it is safe to do
