Range Rover Evoque: Liftgate Window Glass
Removal
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
2.
3.
4. CAUTION: The step must be carried out on both sides.
5. CAUTIONS:
Protect the surrounding components.
Protect the surrounding paintwork to avoid damage.
- Use a glazing cutting wire to cut the sealant.
- Pull glazing wire through windshield sealant to the inside of the vehicle.
6. NOTE: This step requires the aid of another technician.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of foreign material.
Correct preparation of body apertures 'post painting' to ensure satisfactory glass adhesion, must be carried out in line with industry practise.
2. NOTE: Install new spacers.
3. CAUTION: The tailgate is manufactured from plastic. Make sure that appropriate bonding component is applied before the PU adhesive.
4. Prepare the window glass, window glass flange and trimmed PU adhesive in accordance with the instructions included with the PU adhesive kit.
5. NOTE: This step requires the aid of another technician.
6. Test the sealer for leaks, apply additional sealer if necessary. If water is used, allow sealer to dry before testing. Spray water around the glass and check for leaks. Mark any area that leaks. Dry the glass and sealer then apply additional sealer.
7. To install, reverse the removal procedure.
READ NEXT:
Windshield Glass
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Lay the glass on felt covered supports. Do no
Front Door Window Regulator and Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: To avoid accidental deployment, the restraints
control module backup power supply must be depleted. Wait at
Glass Roof Panel
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Measure all gaps between the glass roof panel
SEE MORE:
Folding and raising the rear seats
Folding and raising the rear seats
The split fold rear seat of 5 door models can be
folded completely, or partially at 60/40 split, to
accommodate loads and still retain seating for
passengers.
To fold part or all of the seat:
1. Fully lower the head restraints.
2. Press either seat backres
Evaporator RHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
All vehicle
