Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
Replacing remote control batteries

With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.

READ NEXT:

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

 Cup holders and storage

Cup holders and storage 1. Glovebox. 2. Inside the glovebox is a drop down storage area for the Owner’s Handbook pack. 3. Cubby box. 4. Sliding top to reveal cup holders. Do not drink, or u

SEE MORE:

 Blind Spot Monitoring Module (SODL/SODR)

Blind Spot Monitoring System Module (SODL/SODR)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. &

 Glass Roof Panel Blind Motor

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. NOTE: The step must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and

© 2011-2026 Copyright www.rrevoque.org