Range Rover Evoque: Sand

This program should be used for

This program should be used for terrain which is predominantly soft dry sand or deep gravel.

Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may help. DSC should be switched on again as soon as the difficulty is overcome.

If the sand to be crossed is damp/wet, and sufficiently deep to cause the wheels to sink into the surface, the Mud-Ruts program should be used.

READ NEXT:

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

 Driver override options

Although Dynamic Stability Control is automatically engaged when a special program is selected, it can be turned off if required. See 91, DISABLING DSC. Hill Descent Control (HDC) will be automat

 System difficulties

Use of an incorrect program will impair the vehicle's response to the terrain and can reduce the life of the suspension and drive systems. If the system becomes partially inoperable for any re

SEE MORE:

 Headlamps

Principle of Operation Three types of headlamp are available: Halogen, bi-xenon or Adaptive Front Lighting System (AFS). For a detailed description of the headlamps operation, refer to the relevant Description and Operation section of the workshop manual. REFER to: (417-01 Exterior Lighting) Give

 Fender Apron Panel Front Reinforcement

Removal NOTES: The fender apron panel front reinforcement is manufactured from RP220 and mild steel. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front side member and fender a

© 2011-2026 Copyright www.rrevoque.org