Range Rover Evoque: Seat belt checks
Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage.
The seat belts should be inspected regularly to check for fraying, cuts, wear to the webbing and the condition and security of the mechanism, buckles, adjusters and mounting points.
- With the seat belt fastened, give the webbing near the buckle a quick upward pull. The buckle must remain securely locked.
- With the seat belt unfastened, unreel the seat belt to the limit of its travel. Check that it unreels smoothly with no snatches or snags. Allow the belt to fully retract, again checking for smooth operation.
- Partially unreel the seat belt, then hold the tongue plate and give a quick forward pull.
The mechanism must lock and prevent any further unreeling.
If any of the seat belts fail to meet those criteria, immediately contact you Land Rover Dealer/Authorised Repairer.
READ NEXT:
Seat belt reminder
Seat belt reminder
If a front seat belt is not fastened
when the vehicle is in motion, a
chime will be heard and the seat
belt warning lamp will illuminate.
Note: Objects on the front passenger
Beltminder
A front and rear seat Beltminder system warns
the driver when the seat belt of an occupied
seat is not fastened or is unfastened during a
journey.
Beltminder
A graphic accompanied by a text mes
Child seats
For optimum
safety, children should
travel in the rear of the vehicle at all
times; front passenger seat travel is
not recommended. However, if it is
essential that a child travels in the
fron
SEE MORE:
Roof Panel Vehicles Without: Sliding
Roof Opening Panel
Removal
NOTES:
The roof panel is manufactured from aluminium 6111T4.
The screw in studs must be renewed with the installation of a new roof panel.
1. The roof panel is replaced in conjunction with:
Liftgate
Windshield
Headliner
2. For additional information relating to this repair procedure p
Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.
Side Panel Dimensions
3-door version
5-d
