Range Rover Evoque: Selecting valet mode

Valet mode allows the vehicle to be driven, e.g., by a parking attendant, but leaves the tailgate locked and restricts use of the touch screen.

This prevents access to telephone numbers, navigation addresses and audio system settings.

From the Home menu, select Valet: Enter a four digit Personal identification Number (PIN) (personally chosen). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

After entering the PIN, you will be prompted to enter the PIN again. Enter the same PIN and touch OK to confirm.

A pop-up screen is displayed, confirming your vehicle is now in Valet mode.

READ NEXT:

 Interior protection

The interior protection feature of the full alarm system may be temporarily disabled via Alarm sensors in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU. Note: If the in

 Battery-backed sounder

In certain markets, a battery backed sounder is fitted. This device will sound if it or the vehicle battery is disconnected while the security system is armed.

 Tilt sensor

The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alar

SEE MORE:

 Satellite Digital Audio Radio System Module (SDARS)

Satellite Radio Module (SARM)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES: If the

 To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 second

© 2011-2025 Copyright www.rrevoque.org