Range Rover Evoque: Sensor blockage
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Blind spot monitoring / Sensor blockage
If one of the sensors is completely obscured the BSM system is automatically disabled, the warning indicator dot is displayed in the exterior mirror and the message BSM sensor blocked appears in the message centre.
Note: Blockage testing is only initiated when vehicle speed is above 32km/h (20mph) and will take at least two minutes of accumulated driving above this speed, to determine that the sensor is blocked.
If the sensors become blocked, then please check that there is nothing obscuring the rear bumper and that it is clear from ice, frost and dirt.
Note: The BSM system is inoperative while a trailer is attached and the trailer socket is used.
READ NEXT:
System fault
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
SEE MORE:
Auxiliary power sockets
Auxiliary power sockets
Only use Land Rover approved
accessories. Using any other
equipment may damage the vehicle's
electrical system and/or cause battery
discharge. If you are in any doubt
contact a Land Rover Dealer/Authorised Repairer.
The engine should be running when
using accessori
Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
hig
© 2011-2026 Copyright www.rrevoque.org
