Range Rover Evoque: To erase all programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / To erase all programming
For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in HomeLink have now been cleared.
Note: Do not perform this procedure when programming the additional garage door opener buttons.
READ NEXT:
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Repair procedure
Check the tyre sidewall prior
to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tyre. Do not
stand directly beside the tyre while
the compressor is pumping. Watch the
tyre sidewall: If any cracks, bumps or
similar damage appear, turn off the
com
Steering
Wheel Module
Steering Angle Sensor Module (SASM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
I
© 2011-2026 Copyright www.rrevoque.org
