Range Rover Evoque: Topping up the engine oil

invalidated if damage is caused by Your vehicle warranty may be invalidated if damage is caused by using oil that does not meet the required specification.
Failure to use an oil that meets the required specification could cause excessive engine wear, a build up of sludge and deposits, and increase pollution. It could also lead to engine failure.
Overfilling with oil could result in severe engine damage. Oil should be added in small quantities and the level re-checked to ensure that the engine is not overfilled.

1. Remove the oil filler cap.

2. Add oil to maintain the level between the MIN and MAX marks or notches on the dipstick.

3. Clean up any oil spilled during topping-up.

4. Check the oil level again after 5 minutes.

It is essential to use the correct specification oil and to ensure it is suitable for the climatic conditions in which the vehicle is to be operated.

Note: The approximate quantity of oil required to raise the level from MIN to MAX on the petrol engine dipstick is 0.85 litres (1.5 pints) and on the diesel engine dipstick is 1.5 litres (2.6 pints).

READ NEXT:

 Engine oil specification

It is important that the correct oil specification is used. Vehicles fitted with a diesel particulate filter (DPF) must use the specified oils otherwise significant engine damage will occur. Speci

 Coolant level check

Running the engine without coolant will cause serious engine damage. The coolant level in the expansion tank should be checked at least weekly (more frequently in high mileage or arduous operat

 Topping up the coolant

Never remove the filler cap when the engine is hot - escaping steam or scalding water could cause serious personal injury. Antifreeze is highly inflammable. Do not allow antifreeze to come int

SEE MORE:

 Suspension System - General Information

Coil Spring Suspension Wheel Alignment Specification (All Markets) - Front NOTE: All figures are with vehicle at 'Showroom' ride height - full fluids, full tank of fuel, no occupants/luggage, tires inflated to normal pressures Wheel Alignment Specification (All Markets) - Rear NOTE: All figures a

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steering wheel switches, as follows: - To increase speed, press and hold switch (2) until the green po

© 2011-2026 Copyright www.rrevoque.org