Range Rover Evoque: Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. Torque: 9 Nm

Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console,
Removal and Installation).
4.

5.

6. Torque: 9 Nm

Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
READ NEXT:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse link
Front transverse link
Subframe
Overview
The rear suspension features long travel McPherson stru
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front
Drive Halfshafts, Removal and Installation).
3. R
© 2011-2025 Copyright www.rrevoque.org
