Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the batter
Four-Wheel Drive Systems
Four-Wheel Drive Systems - Component Location
NOTE: Automatic transmission shown, manual transmission similar
Transmission
Power transfer unit
Four-Wheel Drive Systems - Overview
OVERVIEW
The power transfer unit is located at the rear of the engine and is attached
directly to the transmission
© 2011-2025 Copyright www.rrevoque.org
