Range Rover Evoque: Brake systems (amber)

Brake systems (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates after starting the
engine or while driving, suspect worn brake
pads or a fault with the Emergency Brake Assist
(EBA) system. The vehicle can still be driven
with care, but avoid heavy brake application.
Seek qualified assistance urgently.
READ NEXT:
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active.
Dynamic stability control off (amber)
Illuminates when DSC is switched
off.
Deactivating DSC also reduces the
level of Electronic Traction Control intervention
and may lead to an increase in wh
Anti-lock braking system (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
remains on or illuminates while
driving, there is a fault with the ABS system.
Drive with care
SEE MORE:
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The vehicle needs to be stationary for
15 minutes during the sensor fitment before
the system is ready
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer t
© 2011-2025 Copyright www.rrevoque.org
