Range Rover Evoque: Child seat positioning
Crash statistics show that
children are
safest when properly restrained in a
child or infant restraint system that is
secured in a rear seating position.
Information given within the
table is
correct at the time of going to press.
However, availability of child restraints may change. Please consult your Dealer/Authorised Repairer for the latest recommendation.
Note: The information contained in the following table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/Authorised Repairer.
Note: Ages given are approximate. In case of doubt, the child’s weight not age should be used when considering an appropriate child seat.
Note: The legislation which governs how and where children should be carried when travelling in a vehicle, is subject to change. It is the responsibility of the driver to comply with all regulations in force.
U = Suitable for universal category restraints approved for this mass group.
* Always ensure that the passenger airbag has been disabled before using a child restraint in this seating position. See 36, DISABLING THE PASSENGER AIRBAG (not Australia). The seat back needs to be adjusted to the fully upright position.
READ NEXT:
Recommended child seats
Recommended child seats
Child restraint check list
Every time a child travels in the vehicle observe
the following:
- Use appropriate child restraints.
- Carefully follow the restraint system
manufacturers instructions.
- Adjust the harnesses for
Isofix anchor points (not Australia)
Do not attempt to fit ISOFIX
restraints
to the centre rear seating position.
The anchor bars are not designed to
hold an ISOFIX restraint in this
position.
If the restraint is not correctly
a
SEE MORE:
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open or to
the pre
About This Manual
Introduction
This manual has been written in a format that is designed to meet the needs
of technicians worldwide. The objective is to
use common formats and include similar content in each manual.
This manual provides general descriptions for accomplishing diagnosis and
testing, service and repa
