Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Transmission GTDi 2.0L Petrol - Removal

Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine JLR-303-1591 Lifting Bracket, Engine - Rear General Equipment Transmission jack NOTE: Some variation in the illustrations may occur, but the essential information is alway

 Blind spot monitor

The Blind Spot Monitor (BSM) system is a supplement to, not a replacement for, a safe driving style and use of the exterior and rear-view mirrors. Please note that BSM may not be able to give adequate warning of vehicles approaching very quickly from behind or vehicles that are being overt

© 2011-2025 Copyright www.rrevoque.org