Range Rover Evoque: Front seat heaters

Press the relevant button to operate the required seat heater at high level. Three indicators will illuminate.

Press a second time to heat the seat at a medium level. Two indicators will illuminate.

Press a third time to heat the seat at the lowest level. One indicator will illuminate.

Press a fourth time to switch off.

Note: Seat heaters consume a great amount of battery power. They will operate only when the engine is running.

READ NEXT:

 Recirculation

- Press briefly to activate timed recirculation. The button indicator illuminates when recirculation is on. - Press and hold the button to activate latched recirculation. The button indicator wil

 Recirculation with pollution and humidity sensing

- Press the AUTO button briefly to activate timed recirculation. The AUTO LED will illuminate. The system automatically selects fresh and recirculated air dependent on pollution and cabin humidit

 Water deposits

The climate control system removes moisture from the air and deposits the excess water beneath the vehicle. Puddles may form but this is normal and is no cause for concern.

SEE MORE:

 Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. WARNING: Make sure that

 Multifunction Electronic Modules

Torque Specifications Front Door Module (FDM) Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Front Door Trim Panel (501-05 Interior

© 2011-2025 Copyright www.rrevoque.org