Range Rover Evoque: Front Stabilizer Bar Bushing

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. Remove the front wheels and tires.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. WARNING: Make sure that new nuts are installed.

Torque:

Stage 1: 175 Nm
Stage 2: 175 Nm

Range Rover Evoque. Front Suspension

Installation

1. To install, reverse the removal procedure.

Front Stabilizer Bar Link

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. WARNING: Make sure that new nuts are installed.

CAUTION: Use an Allen key to prevent the ball joint rotating whilst removing the nut.

Torque: 60 Nm

Range Rover Evoque. Front Suspension

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Wheel Knuckle

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the sus

 Front Shock Absorber Vehicles Without: Dynamic Suspension

General Equipment Suspension Spring Compressor Vise Removal WARNINGS: Make sure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifcations sectio

 Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block Removal CAUTION: Nuts and bolts must be

SEE MORE:

 Roof racks

A loaded roof rack can reduce the stability of the vehicle, particularly when cornering and during cross winds. Driving off road with a loaded roof rack is not recommended. Fit only a roof rack system that is designed for use with your vehicle. For further information, consult your Land R

 Vehicle Recovery

Towing Points CAUTION: The single towing points at the front and rear of the vehicle are designed for vehicle recovery purposes only and must NOT be used to tow a trailer or caravan. The front towing eye is accessible after releasing the 2 toggle fasteners securing the towing eye access panel

© 2011-2025 Copyright www.rrevoque.org