Range Rover Evoque: Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW
Windscreen VIN - China only
VIN label - UK, Europe and ROW
- Type/Approval Number - If shown
- VIN Number
- Gross Vehicle Weight
- Gross Trailer Weight
- Front Axle Weight
- Rear Axle Weight
- Colour Code Group
VIN label - China
- Vehicle VIN Number
- Engine Type/Capacity/Power
- Occupancy
- Build Date
- Gross Vehicle Weight
- Gross Trailer Weight
VIN label - Gulf markets
- Build Date
- Model year
- Vehicle VIN Number
Tire Data Label - UK, Europe and ROW
- Tire Size
- Tire Pressures
Certification/Tire data label - NAS only
- Vehicle VIN Number
- Bar Code Identification
- Tire Pressures
Tire pressure label - Canada only
- Tire Pressures
- Vehicle VIN Number
- Vehicle Type
VIN number identification
VIN number - UK, EU and ROW
VIN number - NAS and Canada
2.2 Liter Diesel Engine Serial Number
The 2.2 Liter Diesel Engine Serial Number is stamped on the RH side of the cylinder block.
2.0 Liter Petrol Engine Serial Number
The 2.0 Liter Petrol Engine Serial Number is etched into the RH side of the engine block.
Automatic Transmission Serial Number
The Automatic Transmission Serial Number is stamped on the LH side of the transmission casing.
Manual Transmission Serial Number
The Manual Transmission Serial Number is stamped on the transmission casing.
Rear Differential Serial Number
The Rear Differential Serial Number is stamped on the side of the differential casing.
Power transfer unit
The number is stamped on the underside of the casing.
READ NEXT:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Lifting
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
SEE MORE:
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
