Range Rover Evoque: Liftgate Window Glass
Removal
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
2.
3.
4. CAUTION: The step must be carried out on both sides.
5. CAUTIONS:
Protect the surrounding components.
Protect the surrounding paintwork to avoid damage.
- Use a glazing cutting wire to cut the sealant.
- Pull glazing wire through windshield sealant to the inside of the vehicle.
6. NOTE: This step requires the aid of another technician.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of foreign material.
Correct preparation of body apertures 'post painting' to ensure satisfactory glass adhesion, must be carried out in line with industry practise.
2. NOTE: Install new spacers.
3. CAUTION: The tailgate is manufactured from plastic. Make sure that appropriate bonding component is applied before the PU adhesive.
4. Prepare the window glass, window glass flange and trimmed PU adhesive in accordance with the instructions included with the PU adhesive kit.
5. NOTE: This step requires the aid of another technician.
6. Test the sealer for leaks, apply additional sealer if necessary. If water is used, allow sealer to dry before testing. Spray water around the glass and check for leaks. Mark any area that leaks. Dry the glass and sealer then apply additional sealer.
7. To install, reverse the removal procedure.
READ NEXT:
Windshield Glass
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Lay the glass on felt covered supports. Do no
Front Door Window Regulator and Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: To avoid accidental deployment, the restraints
control module backup power supply must be depleted. Wait at
Glass Roof Panel
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Measure all gaps between the glass roof panel
SEE MORE:
Health and Safety Precautions
Introduction
Modern vehicles contain many materials and liquids which if not handled with
care can be hazardous to both personal
health and the environment. Also, many of the procedures associated with vehicle
maintenance and repair involve physical
hazards or other risks to health.
This subsecti
Supplemental Restraint System (SRS) Health and
Safety Precautions
WARNINGS:
Only qualified technicians are allowed to work on pyrotechnic components.
INHALED: Exposure to pyrotechnic residue may cause low blood pressure, severe
headache, irritation of mucous
membranes, fainting, shortness of breath or rapid pulse. Move a victim to fresh
air. Seek immediate m
