Range Rover Evoque: Opening and closing the bonnet
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Fluid level checks / Opening and closing the bonnet
Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the left-hand front footwell.
2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catch alone.
3. Lower the bonnet until the safety catch engages. Using both hands, press the bonnet down until the catches click. Check that both catches are engaged by trying to lift the front edge of the bonnet.
READ NEXT:
Poisonous fluids
Fluids used in motor vehicles are poisonous
and should not be consumed or brought into
contact with open wounds.
For your own safety, always read and obey all
instructions printed on labels and co
Used engine oil
Prolonged contact with engine oil may cause
serious skin disorders, including dermatitis
and cancer of the skin. Always wash
thoroughly after contact.
It is illegal to pollute drains,
water
co
Engine compartment overview
Engine compartment overview
2.0L petrol engine
1. Brake/clutch fluid reservoir caps (beneath
covers):
A. Left-hand drive vehicles.
B. Right-hand drive vehicles.
2. Engine oil filler cap.
5. O
SEE MORE:
System fault
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note: Even if the detected fault only affects the
radar sensor on one side of the vehicle, the
whole s
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
© 2011-2025 Copyright www.rrevoque.org
