Range Rover Evoque: Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings.

stop, off Always find a safe place to stop, off the highway and away from traffic.
Ensure that the vehicle and jack are both on firm level ground.
Apply the parking brake. Engage Park (P) on automatic vehicles, select 1st or reverse gear on manual vehicles.
Switch on the hazard warning lamps.
Ensure that the front wheels are in the straight ahead position and engage the steering lock.
Disconnect trailer/caravan from vehicle.
Ensure that all passengers, and animals, are out of the vehicle and in a safe place away from the highway.
Place a warning triangle at a suitable distance behind the vehicle, facing towards oncoming traffic.
Never place anything between the jack and the ground, or the jack and the vehicle.
Do not attempt to raise the vehicle unless the jack head is fully engaged in the jacking point. Only jack the vehicle using the approved jacking points.
Take care when loosening the wheel nuts. The wheel brace may slip off if not properly attached and the wheel nuts may give way suddenly. Either unexpected movement, may cause an injury.
Take care when lifting the spare wheel and removing the punctured wheel.
The wheels are heavy and can cause injuries if not handled correctly.
Do not start or run the engine while the vehicle is supported only by a jack.

READ NEXT:

 Locking wheel nuts

Locking wheel nuts can be removed only by using the special adapter provided in the tool kit. Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It shou

 Releasing locking wheel nuts

1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged. 2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.

 Wheel changing

WARNING - THAT NO PERSON SHOULD PLACE ANY PORTION OF THEIR BODY UNDER A VEHICLE THAT IS SUPPORTED BY A JACK. Position the jack from the side of the vehicle, in line with the appropriate jacking

SEE MORE:

 Headliner

Removal NOTES: Removal steps in this procedure may contain installation details. Vehicles with glass roof panel shown, vehicles without glass roof panel similar. All vehicles 1. Refer to: Windshield Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation). 3-door 2. NOTE: The procedure

 Electrical Precautions

General The following guidelines are intended to make sure the safety of the operator whilst preventing damage to the electrical and electronic components of this vehicle. Equipment Prior to commencing any test procedure on the vehicle, make sure that the relevant test equipment is working correct

© 2011-2025 Copyright www.rrevoque.org