Range Rover Evoque: Anti-trap protection

blind onto Closing a window or roof blind onto any part of the body can result in serious injury.
Before closing a window or the roof blind, ensure that no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system death or serious injury could occur.

Anti-trap protection will stop window or roof blind movement if an obstruction or resistance is detected. Check the window or roof blind and its aperture and remove any obstructions (e.g.

ice, etc.).

If it is still necessary to raise the window, the override procedure is as follows: 1. Attempt to close the window, anti-trap will prevent closure and lower the window slightly.

2. Within ten seconds attempt to raise the window again, anti-trap will prevent closure and lower the window slightly.

3. Attempt to close the window for a third time, this time hold the switch in the close position. Hold until closed.

Note: If this procedure fails to remove the blockage, the window operation may need to be reset.

READ NEXT:

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

 Exterior mirrors

Exterior mirrors 1. Mirror selector switches. Press to select the left or right mirror. 2. Mirror adjustment switch. Move up/down/left or right to adjust the mirror glass. 3. Press both select

SEE MORE:

 Transmission Fluid Pan TD4 2.2L Diesel

Removal CAUTION: Extreme cleanliness must be exercised when handling this component. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Tra

 Suspension Top Mount

Removal NOTES: The suspension top mount is manufactured from mild steel and RP220. The service panel is serviced not fully spot welded. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2.

© 2011-2025 Copyright www.rrevoque.org