Range Rover Evoque: Bulb specification chart
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Technical specifications / Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
vehicle's electrical system.
Note: LED bulbs can be replaced only by a Land Rover Dealer/Authorised Repairer.
READ NEXT:
Smart key system transmitters
1. Steering column backup transmitter.
2. Front cockpit transmitters.
3. Front exterior door handle transmitters.
4. Roof keyless receiver.
5. Floor console front transmitter.
6. Rear exterior
SEE MORE:
Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the batt
Using cruise control
Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: Cruise control is not available when
using Hill Descent Control or when a Terrain
Response special
© 2011-2025 Copyright www.rrevoque.org
