Range Rover Evoque: Mislock
When locking the vehicle with the Smart Key, if one or more of the doors, the bonnet or the tailgate is not fully closed, or the ignition is ON, the vehicle will NOT lock and there will be an audible mislock error warning. The hazard warning lamps will NOT flash and the door mirrors (if enabled) will NOT fold in. Check that all doors, the bonnet and the tailgate are closed properly. Ensure the ignition is turned OFF and lock the vehicle again. If the mislock persists, consult a Land Rover Dealer/Authorised Repairer.
READ NEXT:
Global closing
Ensure that no children,
pets, or
obstructions are in any open aperture
before operating global closing.
Ensure that all doors are closed. Press and
hold the Smart Key lock button for 3 seconds
Keyless locking
Never double lock the vehicle
with
people, children or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quick
Keyless global closing
To initiate global window closing (if enabled),
touch and hold the lock sensor (1) for 3
seconds. This will also single lock the vehicle
and activate the alarm.
Note: The windows will close only w
SEE MORE:
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installat
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
panel is replaced
2. For additional information relating to this repair procedure please see
the foll
© 2011-2025 Copyright www.rrevoque.org
