Range Rover Evoque: Overhead Console

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. CAUTION: Take extra care not to damage the edges of the component.

Range Rover Evoque. Instrument Panel and Console

2.

Range Rover Evoque. Instrument Panel and Console

3. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Instrument Panel and Console

4. CAUTION: Take extra care not to damage the wiring harnesses.

Take precautions to avoid any electrostatic charging, which could damage this comopnent.

Range Rover Evoque. Instrument Panel and Console

5.

Range Rover Evoque. Instrument Panel and Console

6. CAUTION: Take extra care not to damage the wiring harnesses.

Range Rover Evoque. Instrument Panel and Console

7.

Range Rover Evoque. Instrument Panel and Console

8.

Range Rover Evoque. Instrument Panel and Console

Installation

1. CAUTION: Take extra care not to damage the wiring harnesses.

NOTE: If installing a new overhead console, make sure the original blanking plugs are installed to the new component.

To install, reverse the removal procedure.

Range Rover Evoque. Instrument Panel and Console

Glove Compartment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1.

Range Rover Evoque. Instrument Panel and Console

2.

Range Rover Evoque. Instrument Panel and Console

3.

Range Rover Evoque. Instrument Panel and Console

4. NOTES:

Left-hand shown, right-hand similar.

The step must be carried out on both sides.

Range Rover Evoque. Instrument Panel and Console

5.

Range Rover Evoque. Instrument Panel and Console

6. Torque: 4 Nm

Range Rover Evoque. Instrument Panel and Console

7.

Range Rover Evoque. Instrument Panel and Console

8.

Range Rover Evoque. Instrument Panel and Console

9. NOTE: Glove compartment shown removed for clarity.

Range Rover Evoque. Instrument Panel and Console

10. Torque: 6 Nm

Range Rover Evoque. Instrument Panel and Console

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Floor Console Upper Section

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: The procedure must be carried out on both sides. NOTE: LH illustration shown, RH is similar. T

 Handles, Locks, Latches and Entry Systems

 Locks, Latches and Entry Systems

Principle of Operation For a detailed description of the locks, latches and entry systems and operation, refer to the relevant Description and Operation section of the workshop manual REFER to: Handl

SEE MORE:

 Liftgate Window Glass

Removal 1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation). 2. 3. 4. CAUTION: The step must be carried out on both sides. 5. CAUTIONS: Protect the surrounding components. Protect the surrounding paintwork to avoid damage. Use a glazing cutting wire to

 Safety in the garage

If the vehicle has been driven recently, do not touch exhaust and cooling system components until the engine has cooled. Never leave the engine running in an unventilated area - exhaust gases are poisonous and extremely dangerous. Never work or allow any person to place any part of their

© 2011-2026 Copyright www.rrevoque.org