Range Rover Evoque: Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm

2. Torque: 6 Nm

3. Torque: 6 Nm

4.

5.

6.

7. NOTE: Do not disassemble further if the
component is removed for access only.

8. Torque: 0.6 Nm

9.

10. Torque: 1 Nm

11.

Installation
1. To install, reverse the removal procedure.
Liftgate Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. NOTE: Make sure the two metal clips are removed
from the liftgate.

3. NOTE: Do not disassemble further if the
component is removed for access only.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Inst
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side o
SEE MORE:
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 second
Removal
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation,
Removal and Installation).
2.
3.
4. CAUTION: The step must be carried out on both
sides.
5. CAUTIONS:
Protect the surrounding components.
Protect the surrounding paintwork to avoid
damage.
Use a glazing cutting wire to
© 2011-2025 Copyright www.rrevoque.org
