Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Headlamp Adjustment

NOTE: The headlamp setting is 1.2 % below horizontal and parallel. 1. Align the headlamp beam setting equipment to one headlamp. 2. Switch the headlamps on and to dipped beam. 3. NOTE: NAS vehicles have vertical adjustment only. Adjust the headlamps with an Allen Key. Rotate the adjuster 'A' for

 Front Seat Track

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. WARNING: To avoid accidental deployment and possible personal injury, the backup po

© 2011-2026 Copyright www.rrevoque.org