Range Rover Evoque: System difficulties
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for any reason, it may not be possible to select special programs. A warning will be given when selection of a special program is attempted.
If a participating vehicle system becomes temporarily inoperable, the general program will be automatically selected. Once the system returns to normal operation, the previously active program will be re-activated unless the ignition has been turned off in the mean time.
If the system becomes completely inoperable, all of the special program indicators will be switched off and a relevant message will be displayed in the message centre.
READ NEXT:
Terrain response messages
Messages relating to the Terrain response
system are displayed in the message centre.
See 56, INSTRUMENT PANEL.
Most of the messages that appear will be for
information only and require no driver
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd o
SEE MORE:
Transmission Fluid Pan GTDi 2.0L Petrol
Removal
CAUTION: Extreme cleanliness must be exercised when handling this
component.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Eng
Fender Apron Lower Panel
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper
