Range Rover Evoque: To erase all programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / To erase all programming
For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in HomeLink have now been cleared.
Note: Do not perform this procedure when programming the additional garage door opener buttons.
READ NEXT:
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Instrument Panel GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and
Cooling System Partial Draining, Filling
and Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instruction may
result in damage to the engine.
Engine coolant will damage the paint finished surfaces. If
© 2011-2026 Copyright www.rrevoque.org
