Range Rover Evoque: Radiator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
3. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).
4. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
5. Torque: 5 Nm
6.
7.
8. Torque: 5 Nm
9.
10.
11. CAUTION: Take extra care not to damage the component.
12. NOTE: Do not disassemble further if the component is removed for access only.
13. Torque: 3 Nm
14. NOTE: This step is only required if a new component is installed.
15.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure
Cooling System Partial Draining, Filling
and Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instructi
Engine Cooling - Diagnosis and Testing
Principles of Operation
For a detailed description of the cooling system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L
SEE MORE:
Electronic brake distribution (EBD)
EBD controls the balance of braking forces
supplied to the front and rear wheels, in order
to maintain maximum braking efficiency.
If the vehicle has a light load (only the driver in
the vehicle for example), EBD will reduce the
braking force applied to the rear wheels. If the
vehicle is heavi
Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the butt
