Range Rover Evoque: Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
button for 2 seconds, or;
- Press the engine START/STOP button
twice within 2 seconds.
In either case, the warning Engine Stop Button
Pressed will be displayed in the message
centre.
READ NEXT:
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
SEE MORE:
The dedicated remote control has a range of
approximately 100m (328ft). Press and hold
the ON button for two seconds.
Note: Avoid touching the antenna when
operating the ON or OFF button.
Timed climate remote control
1. On button.
2. Off button.
3. LED (operation indicator).
4. Antenna.
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it count
© 2011-2025 Copyright www.rrevoque.org
