Range Rover Evoque: Transfer Case Seal
LH TD4 2.2L Diesel
Special Tool(s)
100-012
Slide Hammer
205-873/1
Remover/Installer, Transfer Case Seal
205-873/2
Protector, Transfer Case Seal
205-873/3
Punch/Screws, Transfer Case Seal
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Power Transfer Unit - TD4 2.2L Diesel (308-07B Transfer
Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66
6-Speed Manual Transmission AWD, Removal and Installation).
3. CAUTIONS:
Take extra care not to damage the seal.
Inspect the seal, replace if damaged

4. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
Take extra care not to damage the mating faces.
- Special Tool(s): 205-873/1
- Special Tool(s): 205-873/2
- Special Tool(s): 205-873/3

5.
- Special Tool(s): 205-873/1
- Special Tool(s): 205-873/2
- Special Tool(s): 205-873/3

6.
- Special Tool(s): 205-873/1
- Special Tool(s): 205-873/2
- Special Tool(s): 205-873/3
- Special Tool(s): 100-012

Installation
1. CAUTION: A soft faced hammer should be used to
avoid damaging the special tool and creating debris.
- Special Tool(s): 205-873/1
- Special Tool(s): 205-873/2
- Special Tool(s): 205-873/3

2. To install, reverse the removal procedure.
3. Refer to: Power Transfer Unit - TD4 2.2L Diesel (308-07B Transfer
Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66
6-Speed Manual Transmission AWD, Removal and Installation).
4. Check and top-up the transfer case fluid level.
Refer to: Transfer Case Fluid Level Check (308-07B Transfer Case -
Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual
Transmission AWD, General Procedures).
READ NEXT:
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installat
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installat
Exhaust System - GTDi 2.0L Petrol
Lubricants, Fluids, Sealers and Adhesives
* Apply to area around sensor threads prior to attempting to remove sensor
General Specification
Torque Specifications
**
SEE MORE:
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the control module or a component
Valet mode allows the vehicle to be driven, e.g.,
by a parking attendant, but leaves the tailgate
locked and restricts use of the touch screen.
This prevents access to telephone numbers,
navigation addresses and audio system
settings.
From the Home menu, select Valet:
Enter a four digit Perso
© 2011-2025 Copyright www.rrevoque.org
